User manual PowerBox Mercury SRS with OLDED Screen and GPS

6
PowerBox-Systems − World Leaders in RC Power Supply Systems
- PowerBox P²BUS
Connect a receiver to the P²BUS output on RX1 and RX2.
- Futaba FASST and FASSTEST
The Mercury SRS works with the S-BUS signal. Many receivers require one output
to be re-assigned to S-BUS:
• R7003SB: no adjustment necessary; signal present at “PORT 1”.
• R7008SB: output 8 must be set to S-BUS, Mode B or Mode D.
• R6303SB: no adjustment necessary; direct S-BUS output tted
• R6308SB(T): output 8 must be set to S-BUS, Mode B or Mode D.
Other receivers with an S-BUS output can also be used; please refer to the set-up
notes included in the instructions supplied with the receiver.
Telemetry: if you wish to use telemetry, you will need the PowerBox Teleconverter,
which is available as an optional extra. This is used to connect the TELE output on
the PowerBox to the S-BUS 2 input of your receiver.
- Spektrum DSM2 and DSMX
If you have a Spektrum system you simply plug in three or four satellites, and all
18 channels are available - without the need for an X-Plus module.
Telemetry: if you wish your transmitter to receive telemetry data, you will need the
Spektrum TM1000. Connect the three-pin TELE output of the PowerBox to the DATA
input of the TM1000. Connect the four-pin TELE output of the PowerBox to the
X-BUS input of the TM1000.
- Jeti
With a Jeti system it is only necessary to set one SAT or EXT output (depending on
the particular receiver) to UDI 16. The remaining adjustments are carried out using
the transmitter’s device manager: Serial output: UDI
Primary settings:
• Signal speed: 10 ms
• PPM settings: Direct
• Failsafe: Inactive (if two receivers are in use; otherwise any setting)