User manual PowerBox Mercury SRS with OLDED Screen and GPS

www.powerbox-systems.com 5
3. MENU
Hold the SET button pressed in for two or three seconds to enter the menu system;
you can now move the cursor using buttons I and II. Hold the SET button pressed in
once you have selected a particular menu point; you can then adjust values and set-
tings using buttons I and II.
4. BASIC SETTINGS
4.1. Selecting the radio control system
The Mercury SRS must be informed which radio control system you wish to use, as
the bus systems of the various manufacturers differ very widely. You only need to
enter this information once.
The unit’s integral SRS system selects one receiver when switched on, and automati-
cally switches over to the second receiver if the signal is lost. Regardless of the type
of radio control system employed, the change-over process takes just a few millise-
conds, and is not noticeable to the pilot. The Mercury SRS can also be operated with
a single receiver.
Select the GENERAL SETTINGS point at the main menu, then press the SET button; the
following screen display appears:
At this point please select the radio control system you wish to use. With most recei-
vers it is necessary to activate the Bus output, and / or set the correct operating mode.
Bear in mind the following points: