User manual PowerBox Mercury SRS with OLDED Screen and GPS
26
PowerBox-Systems − World Leaders in RC Power Supply Systems
- AXIS: at this point you select the axis which is to be adjusted. The Mercury SRS of-
fers six axes: Aileron-R, Aileron-L, Elevator-R, Elevator-L, Rudder-A and Rudder-B.
- FM: here you select the ight mode which you intend to alter. The ight mode is
selected using the transmitter switch you have already assigned (Input Mapping).
- GAIN: this point displays the gain setting, which can be adjusted individually for each
axis and each ight mode. If you nd that gyro gain on one or other of the axes needs
to be increased or reduced, you can simply ne-tune the value at this point using
buttons I and II on the SensorSwitch.
- ATT. ASSIST: Attitude Assist refers to “Heading” mode or “Hold” mode, as described
earlier. It is possible to switch Attitude Assist on or off separately for each gyro axis.
- DIRECTION: this item refers to the direction of effect of the gyro axis. If you are a
newcomer to gyros, please note: the control surface must respond in the same direc-
tion as the part of the model which is moved. For example: if you raise the right-hand
wing, the right-hand aileron must also deect up.
Caution: please don’t confuse this with the direction in which the transmitter cont-
rols operate! It is vital to check the direction of gyro effect very carefully every time
you make any adjustments to the iGyro.
10.3. Gyro Settings
The Gyro Settings menu permits you to adjust the gyro values manually. We recom-
mend that you set up the iGyro using the Setup Assistant and test-y the model using
the Testy Assistant; in the majority of cases it is likely that no further ne-tuning will
be required. However, the following section describes the individual points in case you
ever need to adopt non-standard settings.