User manual PowerBox Mercury SRS with OLDED Screen and GPS
22
PowerBox-Systems − World Leaders in RC Power Supply Systems
The undercarriage should now retract. If not, hold button I pressed in until the valve is
triggered, and the undercarriage retracts. Press the SET button to move on to the next
stage of the procedure:
Connect the servo for the rst nosewheel door to output F. Use the SET button to close
the rst nosewheel door, then conrm by pressing the SET button. In the next screen
display open the rst nosewheel door again.
The next steps are used to set up the second nosewheel door and the two rear wheel
doors. The procedure is identical to that described for the nosewheel doors.
Note: if you are only using one valve for all the wheel doors, you can skip the doors
not required by selecting OK.
Caution: the Door Sequencer Assistant overwrites the Output Mapping! Depending
on the number of doors in your system, outputs C, F, I, L and O will be overwritten
with door sequencer functions.
All the settings are now complete, it will now take a few moments for the Assistant
to create the necessary tasks, and move the doors to the correct position without any
fouling or jamming.
The tasks created by the Assistant are described in detail under Point 9.4. If the timing
(pauses, opening times and closing times) is not exactly as you wish, you can change
the settings manually at any time. You will nd a range of examples of settings in our
PowerBox Forum under FAQ.