User manual PowerBox Mercury SRS with OLDED Screen and GPS

www.powerbox-systems.com 19
- Move the transmitter switch to the “aps extended” position, then press the SET but-
ton again.
- Now set the appropriate end-point using button I or II before concluding the proce-
dure with the SET button.
- Move the transmitter switch to the “retracted” position, then press the SET button
again.
- Now set the corresponding end-point with button I or II, and conclude the procedure
by pressing the SET button.
- Both landing aps will now move synchronously.
8. SETTING UP THE DOOR SEQUENCER
Select the SEQUENCER point at the main menu; this takes you to the following screen
display:
The SETUP ASSISTANT helps you to adjust the gears and doors in a few minutes.
The EXPERT MENU provides a very powerful programming interface, with which you
can program highly individual sequences, or alternatively expand the settings previ-
ously entered using the SETUP ASSISTANT. More on this later.
The SETUP ASSISTANT guides you through the settings: on-screen instructions de-
scribe everything that you have to do. These instructions simply provide supplemen-
tary information which cannot be supplied by the PowerBox itself simply due to the
size of the screen.
The recommended programming procedure is as follows: rst enter the basic settings
using the SETUP ASSISTANT. At this point the system setup will be complete for 90%
of all models. If you wish to add more wheel doors or adjust the sequence to cater for
other details, this can be carried out in the EXPERT MENUE.