User manual PowerBox Mercury SRS with OLDED Screen and GPS

www.powerbox-systems.com 11
Note: for model types with VT (Vector Thrust) it is only possible to engage vector
control in Flight Mode 3. If you subsequently decide that the model needs more com-
plex mixers, select a model without VT (Normal or Delta) and make use of the vector
function at the transmitter.
5.3. Flight mode switch
Assign a three-position switch of your choice at
the transmitter, and check that the travel is set to
-100% to 0% to +100%. At a later point this switch
will be used to call up the gyro functions you have
already set. Move the switch once to all three posi-
tions in turn, and the channel will automatically be
detected. If the ight modes are not in the arran-
gement (direction) you prefer, simply reverse that channel at the transmitter.
5.4. Gain channel
The gain channel is only required for the test-
ight, during which the gyro gain is adjusted to
suit your model perfectly while it is in the air. Once
the set-up ight is complete, this function is disa-
bled automatically. Assign a rotary knob or slider
to a vacant channel at the transmitter, and check
that its travel is set to -100% to +100%. Move the
rotary knob or slider to both end-points in turn, and the channel will be detected au-
tomatically.