user manual

www.powerbox-systems.com 5
receiver is connected, then it must be connected to RX1 for telemetry transmissi-
on. If you have connected a GPS III to the FastTrack input, the Pioneer also sends
the GPS information to the transmitter.
- Futaba S.BUS2
Connect the S.BUS2 output of one or two receivers to RX1 and RX2. If only one
receiver is connected, then it must be connected to RX1 for telemetry transmis-
sion. This receiver must also be set as the telemetry receiver at the transmitter. If
you have connected a GPS III to the FastTrack input, the Pioneer also sends the
GPS information to the transmitter.
In order to receive telemetry data you must enter the Telemetry Sensor menu at
the transmitter, and carry out a Load New process; this completely erases the
list of sensors. Now move to Slot 16 of the sensor list and select PowerBox. The
telemetry data are now displayed in Slot 16 and above. If you have connected a
GPS III to the FastTrack input, the Pioneer also sends the GPS information to the
transmitter.
- Jeti EX-BUS
Set one output of the receivers you wish to use to EX-BUS. The frame rate should
be set to 10 ms, and the Failsafe function must be set to OFF. If only one receiver
is connected, then it must be connected to RX1 for telemetry transmission. If you
have connected a GPS III to the FastTrack input, the Pioneer also sends the GPS
information to the transmitter.
- Spektrum SRXL2
Connect one or two SPM4651T satellites to the Pioneer using the optional ad-
apter lead set (#9192). If only one receiver is connected, it must be connected to
RX1 for telemetry transmission. At the transmitter you will now see the battery