User manual PowerBox iGyro 3xtra

8 PowerBox-Systems − World Leaders in RC Power Supply Systems
4.3. GAIN ADJUSTMENT FOR INDIVIDUAL AXES
All the settings of the iGyro™3xtra can be adjusted using a smartphone running Mobil Terminal
and the BlueCom™ Adapter, or using the PC Terminal program and USB Interface Adapter. The
adjustment most commonly required is the ne-tuning of gain on individual axes. The Gain channel
adjusts gyro gain on all axes simultaneously, whereas the feature described below enables you to
ne-tune the gain on individual axes - without additional equipment.
Switch the iGyro on, then press the button ve times in rapid sequence. Locate the stick which
controls the axis you wish to adjust, and move it once in order to select that axis. Now move the
stick again to alter the gain of this axis (or axes) by 5 %.
For example, if you need to increase or reduce gain on the elevator, move the elevator stick once.
A red LED indicates the centre, i.e. this is the starting point. Now move the stick forward once to
increase elevator gain by 5 %; move it a second time for an additional 5 %. Moving the stick towards
you reduces gain by 5 %. You can check the gain position by observing the LEDs, as each green
LED indicates a 5 % increment.
If you want to ne-tune another axis, move the corresponding stick once in order to select that axis,
then move it again to adjust the gain in 5 % increments.
When you are nished, pressing the button stores all the settings and quits setup mode.
Note: If you select setup mode again, you can adjust the axes by a further 10% in each direction.
Any change you make in this way affects both ranges A and B.