User manual PowerBox iGyro 3xtra
www.powerbox-systems.com 7
- The AILE LEDs light up red: move the aileron stick on the transmitter to the left-hand end-point
press the button
- The ELEV LEDs light up green: move the elevator stick on the transmitter to the bottom end-point
(back) press the button
- The ELEV LEDs light up red: move the elevator stick on the transmitter to the top end-point (for-
ward) press the button
- The RUDDER LED lights up green: move the rudder stick on the transmitter to the right-hand end-
point press the button
- The RUDDER LED lights up red: move the rudder stick on the transmitter to the left-hand end-point
press the button
At the end of this sequence the gyro automatically reverts to normal operating mode. You can now
advance the Gain control, and check the direction of gyro effect. At the same time check that your
programmed mixers are taken into account correctly in the gyro effect.
Once you have correctly set the installed position and end-points, your iGyro™3xtra is ready for the
model’s set-up ight.
Note: If you subsequently alter the trims or end-points (travels), this learning process should be
repeated. Generally speaking, minor changes to the trims or end-points have a barely percep-
tible inuence on the gyro’s action, but if – for example – you use Attitude Assist on aileron, a
trim change will disable this, as Attitude Assist on all iGyros is only active in the learned centre
position.