User manual PowerBox iGyro 3xtra
www.powerbox-systems.com 5
4. SETTING UP
There are two different procedures: one for a model which has already been test-own without a
gyro, and the second for a new, untried model:
a) New model
- Set the installed position
- Test-y the model including trims, differential, etc.
- Learn the centre and end-points
- Set up the iGyro in ight using the Gain control
- Fine-tune the individual axes if necessary
b) Test-own model
- Set the installed position
- Learn the centre and end-points
- Set up the iGyro in ight using the Gain control
- Fine-tune the individual axes if necessary
4.1 SETTING THE INSTALLED POSITION
The installed position of the iGyro™3xtra is detected by dened movements of the model. The rst
step in learning the installed position is to press the white button on the iGyro and hold it pressed
in while you switch the model on.
You can release the button as soon as the red LEDs cycle. Keep the model as still as possible while
the gyro sensor carries out its self-calibration process. The green LED at AILE-A lights up to indicate
that the iGyro is ready.
The next step is to raise the model’s tail briskly - high enough to cause all ve LEDs to light up green
– and hold the model rmly in this position. The elevator outputs also reect this movement, but