User manual Powerbox PowerExpander SRS

4 PowerBox-Systems − World Leaders in RC Power Supply Systems
a) PowerBox P²BUS
Connect a receiver to the P²BUS output on RX1 and RX2.
b) Futaba FASST and FASSTEST
The PowerExpander SRS works with the S-BUS signal. Many receivers require one
output to be re-assigned to S-BUS:
- R7003SB: no adjustment necessary; signal present at “PORT 1”.
- R7008SB: output 8 must be set to S-BUS, Mode B or Mode D.
- R6303SB: no adjustment necessary; direct S-BUS output tted
- R6308SB(T): output 8 must be set to S-BUS, Mode B or Mode D.
Other receivers with an S-BUS output can also be used; please refer to the set-up
notes included in the instructions supplied with the receiver.
c) Spektrum DSM2 and DSMX
If you are using a Spektrum AR 9020, the SRXL output can be used: all eighteen
channels are then available without requiring an X-Plus module. No adjustments
are required: all you have to do is connect the SRXL output to the PowerExpander.
Once again it is also possible to connect two receivers.
d) Graupner HoTT
When a HoTT system is used, the receivers should rst be bound; adjustments can
then be carried out in the Telemetry menu. All receivers require the CH-OUT-TYPE
to be set to SUMD-OF-16.
- GR16 and GR24: SUMD-OF-16 is present at Output 8.
- GR32: SUMD-OF-16 is present at Output S.
e) Jeti EX
With a Jeti system you simply connect one or two R-Sat2 receivers. These should
be bound to the transmitter, and then set either to UDI or EX.