User manual PowerBox Source

www.powerbox-systems.com
5
- Futaba S.BUS2
Connect the backer’s Tele output to the receiver’s S.BUS2 port. A teleconver-
ter is not required. Select the “Load new” point in the Telemetry Sensor menu
in order to empty all the telemetry elds. Set the “PowerBox sensor” to slot 16.
- Multiplex M-Link
Connect the backer’s Tele output to the receiver’s Tele port. The telemetry
value addresses can be set on the PowerBox Source.
- Graupner Hott
Connect the backer’s Tele output to the receiver’s Tele port. The PowerBox
Source appears as a “General Electric” module at the transmitter.
b) Switching on and off
The procedure for switching on and off is very simple, and represents an ef-
fective means of preventing accidental switching. This is the procedure:
Press the SET button on the Sensor Switch, and hold it pressed in: the central
LED lights up red to indicate that the unit is ready for switching. Continue
holding the SET button pressed in while you press buttons I and II in turn. The
backer is now switched on with both batteries.
Switching off requires the same procedure, exactly as described: hold the SET
button pressed in and wait until the central LED lights up red. Now press but-
tons I and II in turn.
Note: The PowerBox Source stores its last switched state. This means
that a backer switched off using the Sensor Switch remains switched off.
Once switched on, the backer can only be switched off again using the
Sensor Switch. Intermittent contact or a break in contact while the unit is
operating cannot switch the backer off.