Operation Manual

Armadillo 9X Sweeper #4100033 Rev. D 07/15

Page 77

PREVENTATIVE MAINTENANCE

Filter Replacement

1. Insert the panel lter.

2. Install the shaker motor assembly.

3. Install and tighten the four lter wing nuts,

washers, and isolators.

4. Reconnect the wire harness connector to the lter

shaker motor.

5. Close the hopper cover and secure the latch.

Filter Cleaning

The dust control lter is a polyester type element

lter. It may be vacuumed, blown out with

compressed air, tapped against the oor or

washed with soap and water.

1. If blown out with compressed air, use 100

psi (689 kPa) or less.

2. If washed with soap and water, use 40 psi

(275 kPa) water pressure or less.

NOTE: Make sure the lters are thoroughly

dried while standing on their side

before installing in the hopper.

Do not install or use a wet lter.