Operation Manual

Armadillo 9X Sweeper #4100033 Rev. D 07/15

Page 64

4. Slightly loosen the bolt on the center of the

bracket.

5. Loosen the locking nut on each of the adjusting

bolts on the side of the bracket closest to the

pump mounting plate.

6. From the operator’s seat, start the engine and

run at half throttle.

7. Turn the adjusting bolts while watching the rear

wheel. Continue to adjust until the

rear wheel does not turn in either direction.

8. Fully open the throttle. Push the directional

control pedal forward and backward to

be sure the pump stays in neutral. Check the

wheel again and adjust as needed until the

wheel remains motionless.

9. Retighten all the locking nuts and bolts.

10. Turn the engine off and lower the machine to the

oor.

SWEEP COMPONENTS

Broom Door Flap Inspection

NOTE: Perform this inspection when the machine

is parked on a level surface.

1. Turn the machine off and lock the parking brake.

2. Inspect broom door aps for wear and damage.

Flap clearance should be 0.125 in (0,3 cm)

above the oor.

3. Worn and damaged aps should be replaced

immediately to maintain proper dust control.

Broom Door Flap Replacement and Adjustment

The aps are attached to the broom doors by a

retainer bar, hex bolts and nuts. To remove the aps,

remove the nuts, bolts and retainer bar. To adjust the

aps, loosen the nuts and bolts, slide the ap up or

down as needed. Retighten the nuts and bolts.

PREVENTATIVE MAINTENANCE