Operation Manual

Armadillo 9X Sweeper #4100033 Rev. D 07/15

Page 55

ELECTRICAL SYSTEM

Battery Cleaning

1. Combine baking soda and water in a strong

solution.

2. Brush the solution over the battery top, including

terminals and cable clamps. Make sure the

solution does not enter the battery.

3. Using a wire brush, clean the terminal posts and

cable clamps.

4. Apply a thin coating of petroleum jelly to the

terminals and cable clamps.

PREVENTATIVE MAINTENANCE

Battery Replacement

CAUTION

Remove the negative battery cable before you

remove the positive battery cable. This is done

to prevent accidental electrical shorting which

can result in personal injury.

1. Disconnect the negative (-) cable and then the

positive (+) cable.

2. Remove the battery.

3. Install the new battery.

4. Connect the positive (+) battery cable rst, then

the negative (-) cable.