Operation Manual

Armadillo 9X Sweeper #4100033 Rev. D 07/15
© 2014-2015 Minuteman International, Inc.
Page 37
ROTARY TRASH RELOCATOR (RTR™)
1. Use the directional control pedal to stop the
machine on a level surface.
2. Move the throttle to the IDLE position.
NOTE: As you complete Steps three and four,
observe the two red lights labeled “1”
and “2” in the upper left corner of the
control panel.
• Light 1 illuminates when the hopper reaches
the minimum height required to use the RTR™
feature.
• Light 2 illuminates when the hopper reaches the
rotation stop point.
3. Pull back Lever 1 to the RAISE position and
hold until Light 1 illuminates, then release.
WARNING
Make sure no one is in the area under or
around the hopper.
4. Pull back Lever 2 to the DUMP position and hold
until Light 2 illuminates, then release.
NOTE: This rotates the hopper, causing the debris
to move from the rear entrance to the front
wall of the hopper. Rotating beyond this
point will cause the debris to be dumped
from the hopper.
5. Push Lever 2 forward to the RETURN position
until the hopper rotates back and stops.
6. Push Lever 1 forward to the LOWER position
until the hopper returns to the normal operating
position.
7. Move the throttle to the RUN position and resume
sweeping.
MACHINE OPERATION