Operation Manual
© 2014-2015 Minuteman International, Inc.
Armadillo 9X Sweeper #4100033 Rev. D 07/15
Page 34
STARTING
WARNING
Before starting the engine, sit in the operator’s
seat and make sure the parking brake is locked.
1. Make sure the directional control pedal is in the
neutral position.
2. Make sure the throttle is in the idle position.
3. LP and Gasoline-powered: Turn the ignition
key to the start position (to the right). When the
engine starts, release the button.
Diesel-powered: Turn the ignition key to the “on”
position (do not try to start). Press down and
hold the Glow Plug Switch for 10-12 seconds,
release the switch. Turn the ignition key to the
start position (clockwise). When the engine
starts, release the key.
OPERATING PROCEDURES
PRE-OPERATION CHECKS
Prior to starting the engine, check the following:
1. Engine oil level is within the operating range.
2. Engine coolant level is within the operating range.
3. Fuel level. For LP powered machines, conrm the
LP tank is turnd on. To turn the valve ON, turn the
valve counter clockwise until it stops. The valve is
located on the LP tank.
4. Hydraulic uid level is within the operating range.
5. Brakes, steering, and directional controls.
6. Signs of uid leaks on and under the machine.
7. Condition of scrubbing brushes. Remove any
strings and debris wrapped around them.
Fluid levels should be within the correct amounts to
opperate the machine.
Brakes, steering and directional controls should be
functioning properly.
Hoses, lines and tanks should be free of damage and
leaks.
MACHINE OPERATION