Instructions / Assembly

Not for
Reproduction
Move Generator to
Safe Operating Location
1. Move generator outside to a flat, level
surface, in an area that will not accumulate
deadly exhaust gas. Engine exhaust contains
carbon monoxide, a poisonous gas that could
kill you in minutes. You CANNOT smell it, see
it, or taste it. Operate ONLY outside far away
from windows, doors and vents. Install carbon
monoxide alarms. DO NOT run this product
inside homes or garages, even if using fans or
opening doors and windows. Direct exhaust
AWAY from windows, doors, and vents.
5
2. To reduce the risk of exhaust heat or exhaust
gases igniting nearby combustible material,
keep at least 5 feet (1.5 m) clearance on all
sides of generator, including overhead.
Start Generator
1. Make sure unit is on a level surface. Disconnect all electrical
loads from the generator.
2. Turn the fuel valve (E) to ON (I) position.
6
3. Move choke lever (F) to CHOKE position ( ).
7
4. Push engine switch (G) to ON (I) position.
8
5. Pull starter rope handle (K) slowly until resistance is felt. Then
pull cord rapidly to overcome compression, prevent kickback,
and start engine.
9
6. Slowly move choke lever (F) to RUN position ( ) as engine
warms.
7
7. If engine does not start, refer to operator’s manual for detailed
starting instructions.
Plug in Items to be Powered
1. Let engine stabilize and warm up for a few minutes after
starting.
2. Plug in and turn on the desired 120 Volt (H) AC, single phase,
60 Hz electrical loads.
3. Push-to-reset circuit breaker (J) is provided to protect the
generator against electrical overload.
NOTICE Exceeding generators wattage/amperage capacity can
damage generator and/or electrical devices connected to it. Refer
to Do Not Overload Generator section of Operator’s Manual.
Shut Down Generator
1. Turn OFF and unplug all electrical loads from generator
panel receptacles. NEVER start or stop engine with electrical
devices plugged in and turned ON.
2. Let engine run at no-load for several minutes to stabilize
internal temperatures of engine and generator.
3. Push engine switch (G) to OFF (0) position.
8
4. Move fuel valve (E) to OFF (0) position.
6
5. To prepare for storage, refer to Operator’s Manual.
Unpack Generator
1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from top to
bottom.
4. Ensure you have all included items prior to assembly.
If items are damaged or missing, call 1-800-743-4115.
Add Engine Oil and Fuel
NOTICE You MUST properly fill engine with oil before attempting
to start generator.
NOTICE DO NOT use unapproved fuel such as E15 and E85.
DO NOT mix oil in fuel or modify engine to run on alternate fuels.
1. Move generator outdoors to a flat, level surface.
2. Clean area around oil fill and remove yellow oil fill
cap/dipstick (
).
3. Using oil funnel (optional), slowly pour contents of provided oil
bottle into oil fill opening to the Full mark (A) on dipstick.
4. Replace oil fill cap and fully tighten.
5. Clean area around fuel cap (
), remove cap.
3
6. Slowly add unleaded gasoline (B) to fuel tank (C). Be careful
not to fill above the baffle (D). This allows adequate space for
fuel expansion as shown.
4
7. Replace fuel cap, and let any spilled fuel evaporate before
starting engine.
Items Included: (Not Shown)
• Operator’s Manual • Bottle of engine oil
Items Needed: (Not Included)
• Carbon monoxide (CO) alarm(s) • Utility knife • Unleaded fuel (minimum 87 octane)
© 2014 Briggs & Stratton Power Products Group, LLC. All rights reserved.
Every effort has been made to ensure that the information in this document is accurate and correct. However, we reserve the right to alter or otherwise improve the product and this document at any time without prior notice and without incurring obligation.
This generator is rated in accordance with CSA (Canadian Standards Association) standard C22.2 No. 100-04 (motors and generators) and PGMA (Portable Generator Manufacturers’ Association) standard PGMA G200 (Standard for Testing and Validating Performance of Portable Generators).
Quick Setup Guide
Portable Generator
Have Questions?
Do not return to store. We can help.
Call Customer Service Toll-Free 1-800-743-4115
or visit our website: www.powerboss-equipment.com
5
7
F
8
80009704, Rev -
4
FUEL
TANK
B
D
C
WARNING Damaged or overloaded electrical cords could
overheat, arc, and burn resulting in death or serious
injury. ONLY use cords rated for your loads. Follow all
safeties on electrical cords. Inspect cord sets before
each use.
3
9
K
6
E
E
X
H
A
U
S
T
(
C
O
)
Basement
Crawlspace
Garage
Attic
Entryway,
Porch
Only use OUTSIDE and
FAR AWAY from windows,
doors and vents.
Direct exhaust AWAY
from windows,
doors and vents.
DO NOT operate in any of the below locations
KEEP
FAR AWAY
Generator too
close to home and
exhaust directed
towards windows,
doors and vents.
CO Alarm
In Living Areas
E
X
H
A
U
S
T
(
C
O
)
A
8
G
H
1
2
1
2
1
2
J
8
WARNING Failure to read and follow the
operator’s manual and all operating
instructions could result in death or serious
injury.
WARNING Engine exhaust contains carbon
monoxide, a poisonous gas that could kill
you in minutes. You CANNOT smell it, see
it, or taste it. Operate ONLY outside far
away from windows, doors and vents. Install carbon
monoxide alarms. DO NOT run this product inside
homes or garages, even if using fans or opening
doors and windows. Direct exhaust AWAY from
windows, doors, and vents.
WARNING Generator voltage could cause
electrical shock or burn resulting in
death or serious injury. DO NOT operate
under wet conditions.
WARNING Fuel and its vapors are extremely
flammable and explosive which could
cause burns, fire or explosion resulting
in death or serious injury. Turn generator
engine OFF and let it cool at least 2 minutes before
removing fuel cap. Let spilled fuel evaporate
before starting engine. Always allow space for fuel
expansion.
WARNING Hot exhaust and reflective exhaust
gases could cause burns and fires
resulting in death or serious injury. Keep
at least 5 ft. (1.5 m) clearance from any
combustibles or structures, including overhead.