Use and Care Manual

Warning and Instruction Guide
Thank you for purchasing a Powerblanket® product!
Rev G
3. FOLDING INSTRUCTIONS
-When folding the blanket avoid creasing and crumpling. Fold lines should have an arch to prevent
damage to the product.
1-Start with the cold side facing
up. Fold one quarter to center,
cold side to cold side as above.
2-Then fold the blanket one
quarter to center again, cold side
to cold side as above.
3-Then fold the blanket in half,
cold side to cold side as above.
Note: Only fold the blanket as many times as necessary to prepare for storage. Excessive folding and
creasing may damage the product! Never fold the blanket hot to hot. Never roll up the product.
4. TROUBLESHOOTING GUIDE
Note: Test only when the product is disconnected from the power source.
-Check the product supply and extension cords to ensure that they are working properly.
-Check the product for any damage. (For example, puncture holes, rips, cuts, tears, nails, staples, form
spikes, or melted/deformed spots.)
-Check the electrical resistance characteristics of the product using an ohmmeter. To do an ohmmeter
test, follow these four steps.
1. Disconnect the plug of the product from the power supply.
2. Inspect the plug and cord for signs of damage. Do not use the product if it has a damaged plug
or cord. If the plug and cord are not damaged, please continue with the troubleshooting.
3. Connect the ohmmeter to the blades of the plug on the blanket (see below). Compare the
meter reading with that shown on the cord tag of the product. The reading should be within +/-
10% of the value on the cord tag. If it is lower by
10%, there may be excessive moisture within the
blanket, or the heater may have been damaged. If it
is higher by 10%, the product may have been
damaged.