Owner's Manual

REMOTE LEVEL Controller Connection

Your PowerBass Xtreme Class D amp includes a Remote Level control module. To connect the Remote Level

Control to the ampliﬁer, simply insert one end of the 6-pin plug into the REMOTE LEVEL port. Plug the other end

into the remote module. Install the module within easy reach on or under your dash.

SPEAKER LOAD

Keep in mind your PowerBass Xtreme Class D ampliﬁer is a High Power Ampliﬁer and not a high current ampli-

ﬁer. In other words it requires a minimum impedance of 2-ohms (1-ohm for the XL-600.1D). If you are unsure

of calculating impedance loads please consult your PowerBass Xtreme dealer before damaging your ampliﬁer.

Too low of an impedance could send the ampliﬁer into protection mode and/or permanently damage the ampliﬁer.

BASS EQ Control

This special feature is designed to provide you more powerful sound quality, and it allows you to increase the

bass output up to +18dB at 45Hz. Keep in mind that more is not always better. Setting the control to the max

(18dB) will stress the ampliﬁer and the speakers and could result in damage.

NOTE: More is not always better. By turning the BASS EQ all the way up to +18dB you can over-

work the ampliﬁer and send the unit into thermal protection.

Fig.13 Bass EQ Control

0dB+18 dB

Fig.14 Remote Level Connection