Owner's Manual

BLUETOOTH INPUT WIRING

Typical 2 ampliﬁer setup

XL-BTR1 as a Source

The XL Powersport Series ampliﬁers all feature a AUX source input. This allows you to use our XL-BTR1

(pictured) or XL-BTRS, instead of a traditional radio as your music source. Above is a typical two ampliﬁer

system—a multi-channel ampliﬁer (our 2-channel XL-250.2 or our 4-4-channel XL-800.4) to power the full

range speakers and a mono bass ampliﬁer (our mono XL-400.1 XL-600.1D) to power the subwoofer(s).

You will need to use a quality shielded 1/8-inch (3.5mm) stereo male to male audio cable (not supplied) for this

type of set up. Route the shielded audio cable using the same care as you would with the RCA interconnect

for a traditional source unit.

NOTE: A side panel AUX Input is available for use with XL-BTR1 or XL-BTRS.* Use of this input

will override (defeat) the RCA low level inputs.

Fig.9 AUX Input using 1/8" (3.5mm)