Owner's Manual

REM (Remote Trigger)

This terminal must be connected to a switched +12V source. Typically, remote turn-on leads are provided at

the source unit that will turn on and off the ampliﬁer in correspondence with the source. If the source unit does

not have a remote turn-on lead, then a power antenna wire can be used. If neither of these leads is available

at the source unit, then a switched +12V supply must be used, like the ACC, +12V.

Run a minimum of 18 gauge wire from the ampliﬁer location to the source of the switched +12V lead. If pos-

sible, route this wire on the same side of the vehicle as your power cable. Connect the source remote output

to the wire. Go back to the ampliﬁer and cut the wire to length. Loosen the screw terminal marked REM on

the ampliﬁer. Insert the stripped (bare) portion of the wire into the terminal and tighten the screw securely.

FUSE REQUIREMENTS

Due to the small size of the PowerBass XL series ampliﬁers, no fuses are incorporated into the panels that

normally protect the unit from excessive current. Instead we have included an in-line fuse holder and fuse

for this purpose.

It is absolutely vital that the main power lead to the ampliﬁer(s) in the system be separately fused within

18-inches (45cm) of the connection to the battery. The value of this additional fuse (or circuit breaker) should

be no greater than the sum of the fuses found on all the equipment being connected to that power wire.

Fig.5 Proper Ground Connection For

UTVs, Motorcycles or Boats

Proper Ground Connection For

UTVs, Motorcycles or Boats