User's Manual

1
2 3
快速无线充电
使用说明
产品 称:无线 充电
输入 压:5V= 2 A , 9V= 1 . 67A(M ax)
输出 率:10W(M ax)
转换 率: 73%(M ax)
充电 离: 8mm
充电线 长:1
注: 上参数 来源于 品实测实际 数会 产品或其他
而有
适用 型手机(有无线 电功能或内 无线 电的手机)
1 . 接通 源后,指 灯常 1S后 灯,自行检 3S
入待 状态
2 . 放上 机对正产 后, 电中出现蓝 呼吸
3 . 手机充满 后,蓝色灯常
4 . 当出现异 时蓝色指示灯闪烁
1 . 使用本产 时,请使用输出电压 5V= 2 A 、9V= 2 A
QC2 . 0/3. 0快速 电功能的有品质 正的适配
2 . 手机背面 电接触面不能有金属 质如铁片指环 属保
壳等
3 . 手机进行 电时,如偶有发现断 充电或发热严 的情况
很可能是手机接收线 与无线充线圈 有完全对准,手
保护套内部有金属异 ,请尝试冷却 机拿掉保护壳再进
正确位置对位
4 . 本产品有 流保护功能,如使用 当产品会关闭 减小
出功率,降低充电速 。为确保安全 检查设备是否有
常或其它使用不当
5 使用环境温度保 在0- 45℃,勿 产品置于水中、火
温度过高(>45℃过低(<-20°C)中。 给儿童接触、
6 . 请使用干 软布清洁表面,清洁 请断开电源。 要用
学品、肥 或者洗涤剂清
7 . 请勿自行 机,用户不正确使用 不正确放置本 品可
导致本产 寿命减低或损坏, 此而带来的责任 属于
修责任或 家责任,敬请凉解
8 下情况苹果手机 无法进入快充(a)苹果手机 量大
60%,(b)i O S版本11. 1 . 2以下,(c )手机温度大于35- 45℃C
充电速度 慢请将无线充电器 至通风良好的环 下在再
试进行充
1
2 3
User Manual
Fast Wireless Charger
Other mobiles need a wireless charging receiver(include android phone and
iPhone) (Note: All devices must be Qi standard)
Product Specification
Input : 9V/1.67A, 5V/2A
Output : 10W(max
Efficiency : ≥73%
Transmission distance : <8mm
Standards : Qi
Attention
1, Please use a 9v/1.67A or 5Vi2A adapter and high quality cable to ensure
charging effect
2, If you want clear the charger, please make sure it is not connected power
supply
Attention:
1. Please keep the charger away from water
or other liquid.
2. If you need to clean the charger, please
make sure it is not connected power supply.
3. Using Environment temperature remains
0-45
The handset requires a center-
emitter for wireless charging
as shown
Standard Accessories
Wireless Charger
USB Cable
User Manual
Product Introduction
Wireless charger is an intelligent product, wit h simpie design and compatible
with any mobile phones with Qistandard. Mobile phone i s without plug when
charging.
which is more convenient and efficient. It can bring you with limit less life
experience aswell as safe and f ree experience with wireless charging function.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) T his device may not cause harmful int erf erenc e, and (2) this device must
accept any interference received, including int erf erenc e that may cause
undesired operation.
RF warning for WPT device:
The equipment complies with FCC radiat ion e xpo
sure limits set forth for an
uncontrolled environment.
Made in China
ROHS
COMPLIANT
This product is compatible with QI standard
This device complies with part 15 of the FCC Rules
292 mm
69 mm
Model NO.: F1
型号:F1
The device can be used in fixed/mobile (equal or greater than 20cm) exposure condition.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.

Summary of content (1 pages)