Daim Ntawv Qhia Tus Neeg Siv

Knowing your V3
Assembling the POWERPLUS V3
1. Flip the box and open the bottom of the box.
Take the POWERPLUS V3 main unit and
Styrofoam packaging out of the box at the
same time.
2. Remove the front and rear bottom tubes from
the sides of the Styrofoam packaging.
(DO NOT open the Styrofoam packaging at
both sides.)
3. Take out the bolts and insert them into the bolt
holes on the main frame.
4. Put the front and rear bottom tubes on the
main frame, then push the bolts into bolt
holes.
5. Use the wrench to tighten the nuts.
6. Flip the entire Styrofoam packaging
to make the POWERPLUS V3 bike
trainer stand upright on the floor
where it will be used. Remove the
Styrofoam packaging on both sides
to complete assembly of the bike
trainer.
7. Install the cassette (sold separately)
into the cassette body and lock the
cassette nut to prevent loosening.
E
Attention:
The POWERPLUS V3 bike trainer cassette body is compatible with
Shimano and SRAM cassette which can be directly installed with an 11-
speed cassette. If you are using a non-11-speed cassette, please fit the
cassette washer on the bottom of the cassette body first before installing
the cassette.
EN-3