User manual

Operating Instructions

Power Peak

B6 EQ-BID

7.4 STARTING CHARGING/DISCHARGING IN MANUAL MODE

Insert

chip

Withdraw

chip

t $POOFDUDIBSHFSUPQPXFSTVQQMZDPOOFDUCBU-

tery pack.

t 1SFTT45"35

t 1SFTT&/5&3UPDPOGJSN45"35JONFOV

t 4FMFDUUIFSFRVJSFEPQFSBUJPOXJUIUIFBJEPGUIF

MODE button.

t 5P NBLF TVSF UIF TUPSFE QBSBNFUFST BSF EJT-

played once again (if not OK, correct values).

t 1SFTTUIF45"35CVUUPOUPTUBSUUIFDIBSHJOHQSP-

cess, an acoustic signal indicates the

status. The working display, containing all impor-

tant parameters, is then shown (see Section 5.2).

t 8JUI UIF uA PS uA CVUUPO ZPV DBO DIBOHF UIF

current during the charging procedure, the new

value flashes before being adopted.

As soon as a BID chip/key is connected to the char-

ger from the start display or from any other menu on

the set-up level the charger switches to the mode

for charging/discharging a battery with BID chip/key

or for programming a BID chip/key. All parameters

for the battery, for which this chip is to be used, can

be set from this menu. In addition, stored charge

or discharge values can be read (see Section 8.3).

The programming menu is exited on removing a BID

chip/key and the Start display is shown again.

8. BID CHIP/KEY

# 30 8561