User manual

Operating Instructions

Power Peak

B6 EQ-BID

SETTING THE DISCHARGING CURRENT

The discharging current can be selected in steps of

0.1 A. Possible setting: 0.1 A to 1.0 A. The maxi-

mum discharging current is dependent on the num-

ber of cells or the battery voltage and the maximum

discharging capacity. The processor in the battery charger limits the maximum discharging

current if the maximum discharging capacity is exceeded.

SETTING THE ACOUSTIC SIGNAL

5 different signals are available; the signal generator

can also be switched off. A new tone is set every

UJNFUIFuAPSUIFuACVUUPOJTQSFTTFEBUUIFTBNF

time the signal sounds once to aid selection.

SETTING THE CUT-OFF TEMPERATURE

This value determines the battery temperature at

which a charging/discharging operation is to finish.

The prerequisite for this function is that a tempe-

rature sensor, correspondingly fitted on the battery,

is connected to the TEMP connection on the battery charger. The range can be set from

¡$UP¡$JOTUFQTPG¡$

SAVING THE SETTINGS

The settings are saved by pressing the ENTER

button. The start display is then shown again (after

confirming FINISH) or the charge/discharge display

(after confirming START).

# 30 8561