User manual

Operating Instructions
Power Peak
®
B6 EQ-BID
15
Alternatively, the battery voltage can be selected in
2V-steps per cell for lead battery packs.
The following selection is available for lead batteries:
Cell count Battery voltage
1 2 Volt
2 4 Volt
3 6 Volt
4 8 Volt
5 10 Volt
6 12 Volt
ENTERING THE BATTERY CAPACITY
The battery capacity can be selected in steps of 100
mAh (PB, 500 mAh). The battery capacity setting for
lithium battery packs mainly serves as the basis for
the 1C charge, i.e. the charging current is automa-
tically set to the corresponding 1C charge of the battery. It additionally serves as a battery
safety function. The selection shown below is available depending on the type of battery:
The value for the battery capacity is adapted to the corresponding type of battery.
type of battery battery capacity
NiCd 100 - 9900 mAh
NiMH 100 - 9900 mAh
LiPo 100 - 9900 mAh
LiIo 100 - 9900 mAh
LiFe 100 - 9900 mAh
Pb (Blei) 0,50 Ah - 20,00 Ah
SETTING THE CHARGING CURRENT
The charging current can be selected in steps of 0.1
A. Possible setting: 0.1 A to 5.0 A. The maximum
charging current is dependent on the number of
cells or the battery voltage and the maximum char-
ging capacity (max. 2C for lithium batteries). The processor in the battery charger limits the
maximum charging current if the maximum charging capacity is exceeded.
# 30 8561
47