Full Product Manual

6
POWERKING 1-800-344-3371 [e-mail]
Chipper Operation
All branches should not exceed 5in diameter. Fresh cut branches and straw are
recommended for best performance. Due to different hardness and moisture content,
the engine may struggle but will continue to chip. Proper insertion of branches is large
diameter to smaller diameter. It is best to put branches with leaves all together. Small
logs are not recommended.
Procedure
1. Make sure chipper is on flat dry surface.
2. Adjust exit chute to location for processed material.
3. Refer to Kohler manual on how to start the engine.
4. Adjust throttle to maximum RPM.
5. Do not stand directly behind entry chute. Stand to the side of entry chute as
material may kick back.
6. Load material from large diameter side.
7. When machine starts to auto-feed, let go of branch.
8. Let it completely process material before adding more.
9. If machine does not auto-feed, you may need to slowly load the branches or use
other branches to guide it in.
Maintenance
Regular maintenance is the way to ensure the best performance and long life of your
machine. Please refer to this manual for proper maintenance procedures.