Use and Care Manual

QVTOOLS, LLC | 2731 CRIMSON CANYON DRIVE, LAS VEGAS, NV 89128
POWERKING 1-800-344-3371 [e-mail]
Removing Stumps
❏ Remove all loose pieces of wood, stones, wire and other debris from the area
before beginning stump removal.
❏ Wind direction should be considered, as it will influence the direction in which
dust and wood chips are directed.
❏ Never operate the grinder after dark. There will be no adequate light for the
operator to use the grinder safely.
❏ Always allow a cold engine time to warm up before cutting a stump.
❏ Only the portion of cutting wheel within the 80 degree area shown below
should engage the stump. Never undercut the stump or use the bottom of the
cutting wheel for cutting purposes.
❏ Never leave controls when the cutting wheel is rotating.
❏ Do not angle engine more than 25 degrees while in operation. Doing so can
cause damage to the engine.
Operating Tips!
❖ Use smooth and comfortable side to side movements while operating.
❖ When you need to cut smaller roots, it may be more effective to do so
before cutting the stump, rather than after.
❖ Should the chip build-up become excessive when cutting, shut off the
machine, wait for the cutting wheel to stop rotating, retract the machine