Use and Care Manual

QVTOOLS, LLC | 2731 CRIMSON CANYON DRIVE, LAS VEGAS, NV 89128
POWERKING 1-800-344-3371 [e-mail]
❏ Never store the equipment with petrol in the tank inside a building where
fumes can reach an open flame or spark. Allow the engine to cool before
moving the grinder.
❏ To reduce fire hazards, keep the engine and petrol storage area free of grass,
dirt, and excessive grease.
❏ Replace worn or damaged parts for safety. If the fuel tank has to be drained,
this should be outdoors.
❏ Regularly check the oil level and add some oil or replace it if necessary.
❏ Frequently check the grinder and ensure that all bark and dirt deposits are
removed from beneath the deck.
❏ Lubricate the wheel axle and the bearings with grease regularly.
❏ Check the cutting wheel often. In order to achieve clean work, the blade should
always be sharp and well balanced.
❏ Check the tightening of all bolts and screws at regular intervals. Nuts and bolts
that are worn out or badly tightened can damage the engine or the frame.
❏ If the grinder hits an obstacle violently, stop the grinder and take it to a
specialist for inspection.
Transportation
The stump grinder is designed to be transported via a van or small trailer. The
machine is equipped with grab bars that are to be used for both lifting the machine
and strapping it down. This machine weighs approximately 240lbs (110kg) and
should only be lifted using correct apparatus or an adequate number of people
working as a team.
There are legal road requirements for towing equipment and trailers (such as lighting
and licensing). It is the owners responsibility to be aware of these laws and to adhere
to them.
Green Teeth Compatibility
The installed cutting wheel can support Green Teeth’s 500 Series Pockets.
500LP-A - 500 Series LoPro Pocket – Angle – qty 4
500LP-S - 500 Series LoPro Pocket – Straight – qty 4
LP-200 – LoPro Bolts 2” – qty 8
500TH-G – 500 Series Standard Dish Green Tooth w/ Nut – qty 8