SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” SPARES LIST & MAINTENANCE INSTRUCTIONS Manual: MM-SBG(PG)-E-03 SUPPLIED BY: POWER JACKS LIMITED
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” CONTENTS 1. UNIT DETAILS .............................................................................................................................................................................. 2 2. GENERAL NOTES ON SAFETY ................................................................................................................................................ 2 3. MANUFACTURER’S DESIGNATED USE .........................................................
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” 3. Manufacturer’s Designated Use POWERGEAR gearboxes are components for installation in machinery and plant and are designed exclusively for the deflection and multiplication of torques within a speed range up to 6000 rpm. They are compliant with machinery directives (EN 292) and EMC directives, where applicable. Use other than or over and above that described above is contrary to the manufacturer's designated use.
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” 7. General Arrangement & Parts List 7.1 General Arrangement type plate tighten screw torque 10 Nm additional grease in a semicircle secured with Loctite 243 7.
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” 8.
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” With mineral oil types, we recommend to make a first oil change after 500 operating hours and after any 5000 operating hours in each case thereafter. When running the gearboxes with synthetic oil types and on continuous duty near to the thermal load limit, we recommend to perform an oil change after any 10, 000 operating hours and, if running them under usual conditions, after 15,000 operating hours in each case.
SPIRAL BEVEL GEARBOXES RANGE “POWERGEAR” 11. Warranty Information 11.1 Limitation of Responsibility The ratings given in this manual were compiled using standard engineering procedures. The ratings are designed to guide the customer in the selection of a unit. We do not guarantee the ratings in specific applications. Prototype testing of every application is recommended before production. Our engineering facilities are available for consultation at all times.
