User's Manual

7
phone and parts repaired by authorized maintenance centers. If any
maintenance services are needed, consult your network service provider
for details.
Non-ionizing radiation
 Connect wireless equipment to antenna using nonradiative cable (such
as coaxial cable). Do not place the antenna close to the human body,
unless there is metal shielding such as metal roof between them. Use
only antenna designed for use with your phone. Using un-authorized
antenna, modifying the antenna, or attaching supplementary can
damage the phone or violate the related regulations, leading to
performance downgrade.
Effective use
 To achieve optimal performance with least power consumption, do not
lay your hand over the area where the embedded antenna lies when
making or answering phone calls. Otherwise it will affect the call quality
and cause the phone to work at a higher power consumption level,
thereby reducing the battery call time and standby time.
RF Power
 The phone is a low power wireless transceiver device. When powered on,
it will transmit and receive RF signals intermittently. The transmission
power is controlled by networking system.
 Getting Started
 Batteries
The battery is included in the package. It is not fully charged out of factory
but it may still be able to power on your phone. Please completely use up
the power of the battery and then charge it for at least 12 hours with your
phone turned off. You battery will reach its optimal state after three cycles
of charge and discharge.
 Installing and uninstalling the battery
To install the battery, remove the back cover from the phone by pressing
firmly on the cover and slide it down. Align the golden contacts of the
battery to the contacts in the phone, and then gently snap down the battery
into place. Re-assemble the back cover.
To uninstall the battery, flip the battery out from the bottom of the battery.
 Charging the battery
Plug the charger into the socket on the side of your phone. Connect the
charger to an AC wall socket. The blinking of the battery level icon indicates
the battery is being charged. When the blinking stops, it indicates the
charging is finished.
During charging, the phone and charger will feel warm to the touch. This is
normal.
Warning:
 The operating ambient temperature range of the charger is 0°C-50°C.
Do not use the charger when the temperature exceeds this limit.
 Use only chargers approved by the phone manufacturer to ensure
safety. Failing to comply with this will violate the terms and conditions
of the warranty.
 Using the battery
The waiting time and calling time capacities specified by the phone
manufacturer are obtained under ideal operating environment. The actual
values will vary with the network condition, operating environment and
operation method.
Please comply with the local regulations on battery disposal (such as
recycling). Do not dispose it as household waste.