User's Manual

2 Getting Started

The following topics will give you all the information needed to set up your RugGear Bluetooth RSM

for the first time.

2.1 Setting up your RugGear RSM:

Refer to the following sections to charge your RugGear RSM.

2.2 Charging the RugGear Bluetooth RSM Battery:

Your RugGear Bluetooth accessory comes with an inbuilt battery. The battery provided along with

your RugGear Bluetooth RSM does not come fully charged. We recommend that you charge the

accessory at least for one hour before you use it for the first time.

Note: With a fully charged battery, the RSM can remain in standby mode for longer duration. If the

battery is completely out of charge, the charging LED appears only after some seconds when the

charger is connected.

Complete the following steps to charge the battery of the accessory.

1. Plug the charger into a power outlet.

2. The charger port is located at the bottom

of the RSM. Insert the micro USB

connector into the port and insert the

other end of the USB cable into the

charger.

Alternatively, you can charge the

accessory with your PC. Insert the Micro

USB connector into the charging port of

the accessory and insert the other end of

the cable into a USB port on your

Laptop/Desktop.

3. If the battery is being charged when the

accessory is switched ON/OFF, only the

battery LED is displayed on the RSM.