User Manual

OVERVIEW

1. DC Power connector for the adapter

2. Speaker output connector for the passive speaker

3. Infrared receiver and status indicator LED

REMOTE CONTROL

INSTALLATION

1. Drill a hole in the ceiling, big enough to fit the speaker (check

technical specification sheet for size).

2. Connect the active speaker with the 12VDC adapter.

3. Connect active and passive speaker with speaker cable (+/-).

4. Insert the speaker in the hole.

5. Tighten each of the adjusting screws firmly. (the locking tabs

will swivel into the rear surface).

6. Place the metal grill.

Power ON / OFF

Short press for join the speaker group

Long press for exit the speaker group

Switch EQ Effect

Volume Up

Volume Down

Play / Pause

Switch UP for the predefined channel

Switch Down for the predefined channel

Short press for switch to the BT play mode

Long press for switch to the BT pair mode

Short press for connect the speaker to the WIFI

Long press for restore to the factory settings

Switch between BT and WIFI