Instruction Manual

2. Install batteries into the remote control.
Using the enclosed screwdriver to open the battery
cover on the remote control (see diagram D). Insert 2
AA batteries (not included) into the battery
compartment, matching polarity (+ and -) marked
inside. Replace the battery cover and secure it.
CHARGING THE BATTERY
1. Turn off the POWER CRAZE™ 2.0 then insert the charging plug into the truck charging socket on the bottom.
The charging plug fits only one way. Dot not force it (see illustration A,B).
2. Connect the USB end of the cable to your computers USB port or a USB wall charger (see diagram C),
The Red CHARGE indicator light turns OFF while charging is in progress.
3. Average charging time is approximately 30 minutes (via 5.0V 2A USB wall charger). The truck
operates for approximately 13-15 minutes on full charge.
4. The red charging indicator turns on when the battery is fully charged.
Note: Periodically examine the charger for external damage. External damage to the charger may result in the
risk of fire, electric shock, or injury to persons. Never use a damaged adapter.
OPERATION
1. Turn your truck on:
• Fully charge your POWER CRAZE™ 2.0 and install 2 new AA batteries into the controller.
• Sync your truck to the remote control and set the truck on the ground.
2. Driving your truck:
• Pull the throttle halfway to drive forward at low speed. Pull the throttle fully to drive at high speed.
• Push the throttle forward to make truck move in reverse.
• Turn the steering control to the counterclockwise to turn the truck left. Turn steering to the clockwise to
turn the truck right.
• To break or quickly stop simply pull or push the throttle in the opposite direction.
SPEED MODE SWITCH
You can drive your POWER CRAZE™ 2.0 in a low or high-speed setting. Simply push the “Speed Mode Switch”
to the right to change from low to high-speed mode.
THROTTLE TRIM
If your POWER CRAZE™ 2.0 automatically goes forward or backward, simply adjust the Throttle Trim until the
POWER CRAZE™ 2.0 remains in a neutral position.
PACKAGE CONTENTS
• POWER CRAZE™ 2.0 High Speed RC Truck
• Remote control
• USB charger
• 4 Spare tires
• Screwdriver
c
A
SYNCING YOUR POWER CRAZE™ 2.0
Your POWER CRAZE™ 2.0 features an automatic 2.4G channel selection system that allows up to 8
people to race side by side in the same wireless range.
For One Player:
1. Before starting, make sure that the power on both your remote control and truck are in the OFF
position. Make sure that there are no other 2.4G devices in the area.
2. Turn ON the truck and set it down on a flat surface the head light will turn on.
3. Turn ON the remote control and pull the throttle all the way down, your truck and remote control
should sync.If pairing fails, repeat steps 1-3.
For Multiple Players:
1. Before starting, make sure that the power on all trucks and controllers are in the OFF position.
Make sure that there are no other 2.4G devices in the area.
2. Each person must sync their truck one at a time to avoid interference.
Follow steps 1 to 3 above.
3. After syncing, leave the truck ON until all players have synced their trucks.
4. If there is interference, all players must turn off their controllers and trucks and restart the syncing
process.
STEERING WHEEL TRIM ADJUSTMENT
TROUBLESHOOTING
Before sending your truck in for repair, please check for a solution below.
Problem
Truck will not move.
Truck does not respond properly to
remote control.
Truck loses connection to remote
control.
Truck battery is fully charged, but
slower than normal.
Possible Cause(s)
Weak batteries; no batteries
Truck and remote not synced properly
Another RC truck may be transmitting on the
same radio frequency
Using truck in a small enclosed area
Using truck indoors
Low batteries in transmitter or vehicle
Driving truck for too long at high speeds, causing
motor to overheat
Solution
Install new batteries in remote control and
recharge the truck.
Refer to sync section and re-sync your truck
and remote.
Move to a new location where no other RC
trucks are present.
Move outdoors to a large open area.
Install new batteries in remote control or
recharge your truck.
Turn truck off for 10-15 minutes.
If the Truck pulls to the right or left, you may need adjust the
steering wheel trim on the bottom of the truck from time to time to
keep your POWER CRAZE™ 2.0 driving straight. (see diagram E)
E
BATTERIES NOT INCLUDED (2XAA)
D
B
Arrow
Mark
Red
Charging
Light
AA
AA
WARNING
DO NOT USE TRUCK IN INCLEMENT WEATHER!
REMOTE DIAGRAM
TRUCK DIAGRAM
ON/ OFF Switch
Speed Mode Switch
Steering Wheel
Shell
Head Lights
Fog
Lights
Tail Lights
Steering
Wheel trim
ON/OFF Switch
Charging Socket
Tire
Throttle Trim
Power Indicator
Throttle