Specifications

KVM over IP Module
5.6.5 Reset to Factory Defaults
This function may be used when you forgot the password to log in the IP-KVM.
Note: The unit will reboot after this command. All current settings will be lost.
.
The following procedures will revert to factory default settings:
1. Connect a RS232 null modem cable from your local console PC to the IP-KVM Serial port.
Configure your terminal emulation program (such as HyperTerminal or PuTTY) to the
following settings: Baudrate 115200, Data/stop bits 8-1, Parity none, Flow control none.
2. Enter the debugging mode via reboot the IP-KVM system and hit the ESC key. There are two
ways to enter the debugging mode:
(a) Power cycle (reboot) the IP-KVM device. Within 2 seconds of booting the IP-KVM, enter
the Esc key a few times to get a => prompt.
(b) Press & hold ESC AND push and release Reset button, and then release ESC in 2 seconds.
The debugging mode window will display as below.
3. Key in “defaults” command and then Enter. The unit will automatically set to factory default
settings and reboot the system.
97 / 110