User Manual

7
Remove the RED/POSTIVE end first
and then the BLACK/NEGATIVE
clamp.
Do not allow the metal ends of the
jumper cables to touch each other or
the RED cables to touch anything
metal on the car.
Now unplug the BLUE end of the
jumper cable from the power bank.This
will reset the jumper cable. In 10
seconds the power bank will power off
automatically.
TO USE A FLASHLIGHT
Press the power button for 3 seconds to
start the LED illumination.
You can then select from 2 modes
(On/SOS) by pressing the power
button lightly in sequence.
8.
Keep the engine running 20 to
30 minutes, or
drive the car to
recharge the battery.
NOTE: If the engine dies shortly after it
has been jump started, or as soon as
the jumper cables are disconnected, it
probably means the vehicle charging
system is not working (bad alternator,
voltage regulator, wiring problem or
loose/dirty battery cables). Please
mechanic or vehicle’s manufacture for
assistance.
POLARITY PROTECTION CIRCUIT STATUS
Status (Light & Sound Indicator)
Mode
Red Light
Green Light
Sound
None
The car battery is ready for jump start.
None
The Power Bank needs to be charged.
On Flashing
Off
JUMP
STARTING