Specifications

CHARGING THE CAPACITOR AND WIRING:
The capacitor must be charged before connecting the Power and Ground cables to the
capacitor. Failure to charge the capacitor will result in a large spark generated from the
rapid inflow of current.
1. To charge the capacitor:
Make capacitor positive terminal connections with amplifier and tighten the bolt. Do
not over-tighten the bolt!
Caution:
Stripped terminals are not covered under the capacitor’s warranty.
2. Connect the ground cables of the battery, amplifier, and capacitor separately to
chassis.
3. Place the supplied charging resistor between the positive terminal of the capacitor and
the battery’s positive terminal. After 5~60 seconds, the capacitor will be fully charged.
Caution:
The resistor will become hot!
4. Immediately after the charging process, take away the charging bulb from the
connecting wire, and connect the positive cable to the positive terminal on the
capacitor.
CAPACITOR WIRING DIAGRAM: