User's Manual

Pairing a Bluetooth Phone to the JC100
Operation
1. For your safety, please park your car before you begin.
2. Power on the JC100. The LCD will automatically begin
seeking a Bluetooth device when powered on, as
indicated by the LCD light flashing blue once every 3
seconds. This initial seeking period lasts approximately
for 1 min and 30 seconds.
3. Place your Bluetooth enabled cell phone close to the
JC100. Be sure to enable the Bluetooth feature on your
cell phone settings menu.
4. Once your phone discovers the JC100, choose the
option to connect to JC100 and then enter the passkey
"0000" using the cell phone keypad. When the pairing
process is complete, the JC100 LCD back light will
remain solid blue.
5. Please note that the pairing procedures are different from
phone to phone. The above example serves as a general
guideline. You only need to do Bluetooth pairing once for
a cell phone. Once paired, the next time the JC100 is
turned on, it will reconnect to your cell phone
automatically as long as your phone has the Bluetooth
feature turned on and is within 20 feet of the JC100.
6. The JC100 can be paired with multiple cell phones, but it
can only remember the last connected phone. To use
another phone, disable Bluetooth under the settings
menu on the last connected phone to release the JC100
connection. The LCD screen will flash blue and the
JC100 will seek a new Bluetooth connection.
If the LCD stops flashing,
press the Phone button on the JC100 to activate seeking
mode again.
8