Manual

Computed kickback angle (CKA) Table
BAR
MODEL P/N Length CHAIN P/N
P3314/P3314WS 952044398 14' 952051209
P3314WSA
P3416 / P3516PR
P4018 / P3818AV
P4018WM / P4018wq"
P4018AV / P4018AV BH
NOTE: If this saw is to be used for com-
mercial logging, a chain brake Js required
and shall not be removed or otherwise dis-
abIed to comply with Federal OSHA Regula-
tions for Commercial Logging.
_I_WARNING: The engine exhaust
from this product contains chemicals known
to the State of California to cause cancer,
birth defects or other reproductive harm.
SAFETY NOTICE: Exposure to vibra_ons
through prolonged use of gasoline powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discon_nue the use of this tool and seek
medicat attention. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power toots on
a contJnuaI and regular basis must monitor
closely their physical condition and the
cond_on of this tool
952044370 16" 952051211
952044418 18" 952051338
CKA without chain brake
33
33
33 °
SPECIAL NOTtC E: Your saw is equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. AII US. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
if you operate a chain saw Jn a state or Iocale
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
FalIure to follow all Safety Rules and Precau-
tions can resuIt in serious injury. If situations
occur which are not covered in this manuaI,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call t-800-554-6723.
STANDARDS: This saw is listed by Under-
writer's Laboratories, Inc., in accordance with:
ANSI B175.1-2000 American National
Standards for Gasoline-Powered Chain
Saws - Safety Requirements
CSA Z62.1-0g Chain Saws - Occupational
Health and Safety
CSA Z62.3-96 Chain Saw Kickback Occu-
pationa_ HeaIth and Safety
Protective gloves (not provided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN (If not
aIready attached)
A_il,WARNING: Ifreceivedassembled,
repeat all steps to ensure your saw is properly
assembled and all fasteners are secure AI-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even when
it is not moving!
1. Loosen and remove the bar nuts and the
clutch cover from the saw.
2. Remove the plastic shipping spacer (if
present).
Clutch cover
Bar nuts Location of
"_ shipping
spacer
Chain adjustment tool
(Bar Tool)