Manual

Computed kickback angle (CKA) Table
BAR
MODEL
P3314 / P3314WS
P3314WSA
P3416 / P9516PR
P4018 / P3818AV
P4018WM / P4018wq"
P4018AV / P4018AV BH
P/N Length CHAIN P/N
952044368 14" 952051209
952044370 16" 952051211
952044418 18" 952051338
CKA without chain brake
33
33
33
NOTE: If this saw is to be used for com-
mercial logging, a chain brake is required
and shaII not be removed or otherwise dis-
abIed to comply with Federal OSHA Regula-
tions for Commercial Logging.
_kWARNING: The engine exhaust
from this product contains chemicals known
to the State of California to cause cancer,
birth defects or other reproductive harm.
SAFETY NOTICE: Exposure to vibrafions
through prolonged use of gasoline powered
hand tools could cause blood vesseI or neP_e
damage in the fingers, hands, and joints of
people prone to circulation disorders or
abnormal swellings. Prolonged use in cold
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color or texture,
or loss of feeling in the fingers, hands, or joints,
discon_nue the use of this tool and seek
medica_ attenfion. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power too_s on
a continuat and regular basis must monitor
closely their physical condition and the
cond_on of this tool
SPECIAL NOTtC E: Your saw is equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All US. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
If you operate a chain saw in a state or Ioca}e
where such regulations exist, you are legally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failure to follow all Safety Rules and Precau-
tions can result inserious injury. If situations
occur which are not covered in this manuaI,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call t-800-554-8723.
STANDARDS: This saw is Iisted by Under-
writer's Laboratories, Inc., in accordance w_th:
ANSI B175.1-2000 American Nafional
Standards for Gasoline-Powered Chain
Saws - Safety Requirements
CSA Z62.1-03 Chain Saws - Occupational
Health and Safety
CSA Z62.3-96 Chain Saw Kickback Occu-
pationaI Hea_th and Safety
Protective g}oves (not provided) should be
worn during assembly.
ATTACHING THE BAR & CHAIN (If not
aIready attached)
WARNING: If received assembled,
repeat all steps to ensure your saw isproperly
assembled and all fasteners are secure AI-
ways wear gloves when handling the chain.
The chain issharp and can cut you even when
it is not moving!
1. Loosen and remove the bar nuts and the
clutch cover from the sew.
2. Remove the plastic shipping spacer (if
present).
Clutch cover
Bar nuts Location of
"_ shipping
spacer
Chain adjustment tool
(Bar TooI) _4======_
3. An adjusting pin and screw is used to ad-
just the tension of the chain it isvery im-
portant when assembling the bar, that the
pin located on the adjusting screw aligns
into a hole in the bar. Turning the screw will