Assembly Instruction

Pottery barn kids

OPEN TOY BOX

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clean carpeted or scratch-free work

surface (The shipping box provides and ideal work surface). This will avoid damaging any parts

during assembly. Do not dispose of any contents until assembly is completed to avoid accidentally

discarding small parts or hardware.

• Two people are recommended for ease of assembly.

• Use the parts and hardware lists to identify and separate each of the pieces included prior to

starting assembly.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly

instructions.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or

split wood.

PARTS INCLUDED:

A – Front panel (x1) B – Back panel (x1)

C – Left side panel (x1) D – Right side panel(x1)

E – Bottom Panel (x1)

PAGE 1
Pottery barn kids OPEN TOY BOX PRE-ASSEMBLY: • Remove all parts and hardware from the box and lay out on a clean carpeted or scratch-free work surface (The shipping box provides and ideal work surface). This will avoid damaging any parts during assembly. Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware. • Two people are recommended for ease of assembly.
PAGE 2
TOOLS REQUIRED: Phillips head screwdriver (not included) H - Allen Key (included) HARDWARE: F –Allen Bolts 1/4”x 28 x15mm (x8) G–Phillips head screws 8x25mm (x12) ASSEMBLY: 1. On a soft, scratch-free surface such as carpet or rug, lay the Front panel (A) , Back panel (B) , left side panel (C ) and Right side panel (D) as shown , attach them using 8pcs Allen Bolts1/4”x 28 x15mm (F) and Allen Key (H). See illustration.
PAGE 3
2. Put the Bottom panel (E) into the open toy box as shown carefully. 3. Carefully lay the Toy Box on a soft, scratch-free surface as shown in illustration. This position will make assembly easier. Make sure the warning label apply to the bottom of Toy Box inside raised area. And fix the Bottom panel (E) to the Front panel (A) , Back panel (B) , left side panel (C ) and Right side panel (D) using 12pcs Phillips head screws 8x25mm (G).