Assembly Instruction

pottery barn kids

THOMAS DESK

IMPORTANT SAFETY INSTRUCTIONS:

Please read all instructions carefully before assembling.

For your safety, assembly by two people is recommended.

PRE-ASSEMBLY:

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface, as

this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface. Do not

dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware.

• Use the parts and hardware lists above to identify and separate each of the pieces included.

• The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED: HARDWARE ENCLOSED :

(1) Desktop (A)

(1) Drawer Box (B)

(2) Left & Right Side Panel (C)

(1) Back Panel (D)

(4) Leg (E)

(19) Flat washer M6 (F)

(19) Spring washer M6 (G)

(19) JCBC M6x35mm Screw (H)

(1) Allen Key (I)

TOOLS REQUIRED:

Allen Key (included)

ASSEMBLY:

1. Carefully lay the Desktop (A) on your work surface.

2. Gently press down the stopper at the back of drawer to remove the drawer from drawer box (B) and set aside.

(Fig. 1)

3. Remove the keyboard tray from desktop and set aside. Attach Drawer Box (B) to the Desktop (A) until the

dowels are fully secured into the pre-drilled holes. Use the Flat washer (G), Spring washer (G) and JCBC

screw (H) to fasten the connection with Allen key (I). (Fig. 2)

(Fig. 1)

G H F

(Fig. 2)

PAGE 1
pottery barn kids THOMAS DESK IMPORTANT SAFETY INSTRUCTIONS: Please read all instructions carefully before assembling. For your safety, assembly by two people is recommended. PRE-ASSEMBLY: • Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface, as this will avoid damaging any parts during assembly. The shipping box provides an ideal work surface.
PAGE 2
4. Thread the Leg (E) into the Side Panel (C). Turn clockwise until tight. 5. Attach the Back Panel (D) to the Desktop as shown. Locate the dowels on the left side of the Back Panel. Attach the Side Panel to the Back Panel by aligning the pre-drilled holes with dowels. Use Flat washer (F), Spring washer (G) and JCBC screw (H) to fasten the connection with Allen key (I).