Assembly Instruction

Page 1/3

pottery barn kids

THOMAS TWIN/FULL BED

PRE-ASSEMBLY:

• For safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work

surface. Use care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small

parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Read all instructions before beginning assembly. The illustrations provided allow for easier

assembly when used in conjunction with the assembly instructions.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or

split wood.

PARTS INCLUDED:

A - Headboard (1 pc)

B - Footboard (1 pc)

C - Side rail (2 pc)

D - Finials (4 pc)

E – Feet (4 pc)

F – Slat Roll (1 pc)

TOOLS NEEDED:

Phillips Head Screwdriver (not included)

HARDWARE INCLUDED:

G. Phillips Head Screws (28 pc) 8x30mm

PAGE 1
pottery barn kids THOMAS TWIN/FULL BED PRE-ASSEMBLY: • For safety and ease, assembly by two adults is recommended. • Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use care as some parts or hardware may have sharp points or edges. • Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware. • Use the parts and hardware lists to identify and separate each of the pieces included.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Attach the feet (E) to the bottom posts of the headboard and footboard as shown. Important: The bottom of the bedpost has 4 holes, while the top of the bedpost has 3 holes. 2. Attach the side rails (C) to the headboard and footboard by inserting the hooked ends into the corresponding slots. NOTE: Side rails (C) are adjustable to two heights.
PAGE 3
4. Lay slat roll in place onto the inner ledges of the siderails (C). Attach slats by inserting the Phillips screws (J) through the pre-drilled end holes and tightening with Phillips screwdriver (not included). 5.Periodically tighten screws. CARE INSTRUCTIONS: • Dust often using a clean, soft, dry lint-free cloth. • Blot spills immediately, and wipe with a clean, damp, cloth. • We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.