Assembly Instruction

Page 1/3

pottery barn kids

TEEPEE

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly

when used in conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all part and hardware from the box and lay out on a clean, carpeted, or scratch- free work

surface. Use care as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts

and hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause

the bolts misalign during assembly.

• The use of power tools for assembly is not recommended. Power tools can damage hardware or split

wood.

PARTS INCLUDED:

Posts (10)

Plastic Connectors (5)

PARTS REQUIRED (packaged separately):

Teepee Fabric Cover (1)

Fabric Tie (1)

HARDWARE INCLUDED:

Bolt and Nut Set (10)

TOOLS REQUIRED:

Allen Key (included) (1)

Wrench (included) (1)

ASSEMBLY INSTRUCTIONS:

1. Connect (2) Posts (A) to one Plastic Connector (B), (Figure 1). Repeat until all (5) Teepee Poles are

assembled.

PAGE 1
pottery barn kids TEEPEE PRE-ASSEMBLY: • Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. For your safety and ease, assembly by two adults is recommended. Remove all part and hardware from the box and lay out on a clean, carpeted, or scratch- free work surface. Use care as some parts or hardware may have sharp points or edges.
PAGE 2
. Secure each Pole with (2) Bolt and Nut Sets (E) on the Plastic Connectors (B) (Figure 2). F A E E B G A 3. Align the poles and thread the Fabric Tie (D) through the predrilled holes, as shown. A D 4. Tie the the thread in a loose knot, leaving approximately 5 inches of the Fabric Tie exposed between the poles and the knot.
PAGE 3
5. Insert the assembled poles through the top of the Fabric Cover. Then, insert each pole through the middle cuff and into the bottom cuff on the interior of the Teepee Fabric, as shown. Ensure that the poles are inserted into the cuffs in the same sequence in which they are tied together. A C 6. Turn the Teepee upright and spread posts apart. For best results, follow these steps to adjust the Teepee: First, pull the fabric cover upward with two hands.