Assembly Instruction

Page 2/5
ASSEMBLY INSTRUCTIONS:
1. Insert (4) Wood Dowels (H) into the pre-drilled holes on each Side Panel (B) (Figure 1). Then,
fasten the Cam Lock Bolts (G) into the (4) predrilled holes in each End Panel (A), using the Phillips
Head Screwdriver as shown in Figure 2. Do not over tighten the Cam Lock Bolts or the Cam
Locks will not properly engage in Steps 2 and 3.
Figure
1. Figure 2
2. Attach the (2) Side Panels (B) onto one End Panel (A), as shown. Insert (1) Cam Lock (F) into the (4)
corresponding holes on the Side Panels (B) and tighten using Phillips Head Screwdriver. (Figure 3)
3. Insert the Back Panel (D) through the U-groove on the side panel (B) (Figure 4). Place the
second End panel (A) onto the semi-assembled base, as shown. Insert the Cam Lock (F) into the
(4) corresponding pre-drilled holes on the Side Panels (B), then use Phillips screwdriver to fasten
(Figure 5).
Figure 3 Figure 4 Figure 5
D