Assembly Instruction

Page 1/3

pottery barn kids

OLIVIA CHIFFONIER

PRE-ASSEMBLY:

• Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in

conjunction with the assembly instructions.

• For your safety and ease, assembly by two adults is recommended.

• Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use care

as some parts or hardware may have sharp points or edges.

• Do not dispose of any contents until assembly is completed to avoid accidentally discarding small parts or hardware.

• Use the parts and hardware lists to identify and separate each of the pieces included.

• Note: Do not fully tighten all bolts until all parts are in place. Failure to follow these instructions may cause the

bolts to misalign during assembly.

• If using power tools to aid in assembly please use caution. Power tools can damage hardware or split wood.

PARTS INCLUDED:

(A) Chiffonier - 1pc

(B) Leg - 4pcs

(D) Hanging rod - 1pc

HARDWARE ENCLOSED:

(E) Knobs - 3pcs

(F) #4x15mm Screw -3pcs

(G) Shelf Supports - 8pcs

TOOLS REQUIRED:

Phillips head screwdriver (not included)

PAGE 1
pottery barn kids OLIVIA CHIFFONIER PRE-ASSEMBLY: • Read all instructions before beginning assembly. The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions. • For your safety and ease, assembly by two adults is recommended. • Remove all parts and hardware from the box and lay out on a clean, carpeted, or scratch-free work surface. Use care as some parts or hardware may have sharp points or edges.
PAGE 2
ASSEMBLY INSTRUCTIONS: 1. Lay Chiffonier (A) down on a soft surface such as a carpet. Attach the Legs (B) to the Chiffonier (A) (see Fig. 1). Turn the Chiffonier (A) upright. (Fig. 1) B A B B 2. Fasten Knobs (E) to door and drawer using Screws (F). Tighten with Phillips head screwdriver. Place the Hanging rod (D) onto the block mounted inside the Chiffonnier (A) as shown. (See Fig.2) (Fig.
PAGE 3
. To install Adjustable Shelves (C), insert (4) Shelf Supports (G) into the pre-drilled holes on the inner side panels of Chiffonier (A) at the desired height. Carefully place the Adjustable shelf (C) onto the Shelf Supports (G). Repeat with second Adjustable Shelf (C). Make sure each Adjustable Shelf (C) is properly supported by all (4) Shelf Supports (G). (See Fig.3) (Fig. 3) C G C 4. If your floor is not perfectly even, the furniture may not sit level.