Assembly Instruction

MOUNTING INSTRUCTIONS:

• Attach one of the Mounting Brackets (X) to an area near the top back edge of the furniture using a

Short Screw for Product Bracket (Y).

• Determine the final position of the furniture. Mark location on the wall approximately 2” below the

Mounting Bracket (X) mounted to the back of the furniture.

• Drill a starter hole into the wall stud. If wall stud is not available, drill a hole into the wall and screw

another Mounting Bracket (X) into the wall with a Long Screw for Wall Bracket (Z1).

• Place the furniture so the Mounting Bracket (X) on the back edge is in line with the Mounting Bracket

(X) on the wall.

• Lace end of the Nylon Restraint Strap (Z2) down through each Mounting Bracket (X). Bring both ends

together and slide the beaded end until it snap locks into the keyhole slot.

• Check to make sure the Nylon Restraint Strap (Z2) is securely laced and locked to the Mounting

Brackets (X).

(Fig. 11)

NOTE: You can combine with another product of the series by Sleeve Screw (Z3) and Sleeve Nut (Z4), as shown

in below illustration.