Assembly Instruction

5
FURNITURE TIPPING RESTRAINT
Young children may be injured by tipping furniture. The use of a tipping restraint is highly recommended.
When properly installed, this restraint could provide protection against the unexpected tipping of furniture due to
small tremors, bumping or climbing. We recommend mounting this restraint to a wall stud.
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision.
Hardware Included (also described on page two):
N - Brackets (x 2)
O - Long screws (x 2)
P - Short screws (x 2)
Q - Nylon strap (x 1)
INSTALLATION INSTRUCTIONS:
1. Locate a wall stud behind your furniture, Position a bracket (N) on the stud approximately 1” below the
top of the furniture. Mark and drill pilot hole into the center of the stud with a 3/32” drill bit. Attach a
bracket (N) to the stud with the long screws (O) provided.
2. On the back of the furniture, a bracket (N) will need to be attached to the furniture frame at the top. To
do this, temporarily move the furniture into its final position and mark the location of the wall bracket on
the furniture frame. Move the furniture away from the wall and place a bracket on the mark. Mark and
drill holes for screws with a 3/32” drill bit. Attach the bracket to the furniture with the short screws (P)
provided.
3. Move the furniture into its final position, taking care to line up the wall bracket with the furniture bracket.
Thread strap (Q) through the bracket as shown in the illustration. Tighten strap until snug. Do not over
tighten