Assembly Instruction

(F) Spring washer 1/4mm
–
8pcs
(G) Nuts 1/4mm
–
8pcs
(H) Spanner
–
1pc
ASSEMBLY
INSTR
UCTIONS
:
1.
Insert the Bolts (D) into the pre
-
drilled holes on Leg (B) as shown. Insert the Bolts (D) into the pre
-
drilled holes
on the top of the leg (B) to receive the Nut (C). Tighten with a screwdriver, but do not over tight.
Repeat same
process for
the other 3
L
egs. (Fig. 1)
.
(Fig. 1)
2.
Lay tabletop (A) face down on your work surface and position one of the Desk legs (B) exactly as shown in
illustration below.
Align the pre
-
drilled holes in each leg with the pr
e
-
drilled holes in the corner braces of the
table top.. Insert 1 Flat washer (E) and 1 Spring washer (F) and 1 Nut (F) per leg as shown.
Fully tighten with
the enclosed spanner (H).
Repeat same process for the other 3 legs. (Fig.
2
)
(Fig.
2)
B
C
D
A
B
H
E
F
G